Fire Ball

1. Take a file of 400 by 400 pixels (width-400 & height-400), resolution 72, mode RGB color with white background.
2. Click D on the keyboard as to make fore-ground color black & back-ground color white and then Click X on the keyboard as to make fore-ground color white & back-ground color black as shown in (Fig.1).

   

   (Fig.1)

3. The third step is - Go to Filter-Render-Clouds as shown in (Fig.2).

   

   (Fig.2)

4. The forth step is - Go to Filter-Render-Difference Clouds as shown in (Fig.3).

   

   (Fig.3)

5. Now the fifth step is - Go to Filter-Artistic-Plastic Wrap with properties as follows :- Highlight Strength-20 ; Detail-15 ; Smoothness-3 ; & you will get the result as shown in (Fig.4).

   

   (Fig.4)

6. Sixth step - Go to Filter-Stylize-Glowing Edges with properties as follows :- Edge Width-1 ; Edge Brightness-20 ; Smoothness-15 ; & you will get the result as shown in (Fig.5).

   

   (Fig.5)

7. Now selecting the same layer you are working upon, duplicate the layer by shortcut command Ctrl + J (Fig.6) & then change the blending mode to color burn as shown in (Fig.7), you will get the result as shown in (Fig.8).

   

   (Fig.6)

   

   (Fig.7)

   

   (Fig.8)

8. Selecting the below layer go to Filter-Render-Lens Flare with properties as follows :- Brightness-183 ; Lens Type-50-300mm Zoom ; place the lens in the middle & you will get the result as shown in (Fig.9).

   

   (Fig.9)

9. Now selecting the same below layer, set color by Image-Adjustments-Hue/Saturation or instead of this you can give shortcut command Ctrl + U for Hue & Saturation using properties as shown in (Fig.10).

   

   (Fig.10)

10. Finally you will get your desired result as shown in (Fig.11).

    

    (Fig.11)

11. Thank-you for watching, Regards - Ayush Maheshwari